Adding CPE510 to existing Access point (CPE510)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Adding CPE510 to existing Access point (CPE510)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Harry7579

2022-04-14 06:23:54 - last edited 2022-04-26 06:10:44

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-04-14

Adding CPE510 to existing Access point (CPE510)

2022-04-14 06:23:54 - last edited 2022-04-26 06:10:44

I have two warehouses connected through two CPE510 units. Can i add another warehouse with one more CPE510 to existing Access point or do i need to replace existing access point with a multi point model? If yes which model to buy?

1 Reply

Hank21

2022-04-15 10:50:20 - last edited 2022-04-26 06:10:44

Posts: 3673

Helpful: 729

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Adding CPE510 to existing Access point (CPE510)

2022-04-15 10:50:20 - last edited 2022-04-26 06:10:44

Hi @Harry7579

CPE510 Antenna SPEC: Beam Width: 45° (H-Plane) / 30° (E-Plane)

That means if your 3rd warehouses in the main AP CPE510 face direction angle 60°, you can just add one CPE510 and link it to the main AP CPE510.

WBS is another solution but the main difference is WBS use external antenna, so it can reach more than 60°.

https://www.tp-link.com/us/support/faq/1225/

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Adding CPE510 to existing Access point (CPE510)

Adding CPE510 to existing Access point (CPE510)

Information

Voters 0

Tags