Business Community > Controllers > ALC Connecting to another Subnet
< Controllers

ALC Connecting to another Subnet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ALC Connecting to another Subnet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ALC Connecting to another Subnet
ALC Connecting to another Subnet
2022-04-06 00:50:43
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2.0 Build 20220114 Rel.76871

I am trying to figure out this issue I have with my ACL.

 

I have Subnet 192.168.1.1/24 which is my main network. - VLan 10

I have Subnet 192.168.2.1/24 which is my IoT network - Vlan 20

 

In the ACL I have a Deny from IoT to my main network.

I have a permit from my main network to my IoT.

 

Basically I want my Main network to talk to the IoT network but not the other way around.

 

I can't ping anything on my IoT from my main even though I set a permit and made it higher priority than the deny.

 

Is there something I am missing? 

  0      
 
  0      
 
#1
Options
2 Reply
Re:ALC Connecting to another Subnet
2022-04-06 07:03:27
Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:ALC Connecting to another Subnet
2022-04-06 23:43:57
Everytime I create a group with the same subnet I get kicked out of the controller and have to log in using the local address
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 493

Replies: 2

Related Articles
Can't reserve fixed IP address on another subnet
877 0
 Omada Network Setup with Router on another subnet
52 0
Change IP/Subnet ER605
449 0
Adopt gateway to different subnet question
498 0
Static route to VPN Subnet not working
582 0
 Static route / no connection to other subnet why?
210 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.