ER605 - Priorize Wan1 and use WAN2 too

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 - Priorize Wan1 and use WAN2 too

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 - Priorize Wan1 and use WAN2 too
ER605 - Priorize Wan1 and use WAN2 too
2022-03-18 19:02:26
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version:

Hello Everyone

 

We have purchesed a ER605

I tested failover and works correctly, but i wish to use both ISP´s simultaneously (to take advantage of the bandwidth of the 2 links and not leave 1 of them stopped) 

 

how do i achieve this goal

 

Best Regards

 

Eduard

  0      
  0      
#1
Options
1 Reply
Re:ER605 - Priorize Wan1 and use WAN2 too
2022-03-22 06:44:34

Dear @ACEO

 

ACEO wrote

We have purchesed a ER605

I tested failover and works correctly, but i wish to use both ISP´s simultaneously (to take advantage of the bandwidth of the 2 links and not leave 1 of them stopped) 

how do i achieve this goal

 

You just need to only enable the Load Balancing, and no need to do the link back settings.

Because the load balancing wil not be active when the failover function enabled.

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options