TL-SG2008p LAG LACP no members after adding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG2008p LAG LACP no members after adding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG2008p LAG LACP no members after adding
TL-SG2008p LAG LACP no members after adding
2022-02-25 06:09:31 - last edited 2022-03-01 10:40:50
Model: SG2008P  
Hardware Version: V1
Firmware Version: 1.0.2 Build 20210806 Rel.55686

Hello friends.

I have strange issue with this device. I try to make LACP on 1/0/7-8 using web-interface. And i find few official instructions about that.

 

So everywhere same steps:

  1. L2 Features - LAG - LACP Config
  2. Checkbox enable on few ports, Status - Enabled, Group ID same for marked, Port Priority, Mode

 

After all manipulations go back to LAG Table and didn't see members on my LAG. And LACP didn't work

It is clean device right after reset

f8ebcc6dc3a2440786ed9f544c01a555

  0      
  0      
#1
Options
1 Accepted Solution
Re:TL-SG2008p LAG LACP no members after adding-Solution
2022-03-01 07:58:55 - last edited 2022-03-01 10:40:50

  @devzer0 LAG Table will not show anything if the switch ports are not connected to another LAG device. Once LAG take effect you will see the member ports. https://www.tp-link.com/en/support/faq/991/

 

You may check LACP settings on the another side switch/device, and then have Ethernet cable connected. 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:TL-SG2008p LAG LACP no members after adding-Solution
2022-03-01 07:58:55 - last edited 2022-03-01 10:40:50

  @devzer0 LAG Table will not show anything if the switch ports are not connected to another LAG device. Once LAG take effect you will see the member ports. https://www.tp-link.com/en/support/faq/991/

 

You may check LACP settings on the another side switch/device, and then have Ethernet cable connected. 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options