Internet connection via Omada controller speed drops
expect engineer support advice: My company connects to the internet via the omada controller system with a speed of 100Mbps, but the device can only test the speed at 40Mbps
Connecting devices:
Modem huawei (ISP): internet
TP-Link Switch: TL-SG1008PE
OC200
EAP115: 5 devices
need to check how to connect and configure the device
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Thavone ,
Thavone wrote
expect engineer support advice: My company connects to the internet via the omada controller system with a speed of 100Mbps, but the device can only test the speed at 40Mbps
To better assist you, may I know the clients that is only get 40M which is connecting to your network wired or wireless?
Did you use the speedtest website to test the speed?
What is the link speed when this clients only get 40M?
And this client connect to which device?
Best Regards!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Dear @Thavone ,
Thavone wrote
The clients are connecting wirelessly and I tested it with speedtest and the results are about 30 to 40 Mbps.
clients have connections by mobile, laptop, tablet
If you use the same clients replace one of the EAPs, and connect to the front-end devices with the same cable, what is the result of the speedtest?
It is also possible to speed test the EAP directly with Iperf because it could be able to eliminate as much interference as possible.
Please check this link:
How to use iPerf to test the speed between the EAP and the wireless client?
Best Regards!
- Copy Link
- Report Inappropriate Content
i did the test using iPerf as you advised. and I send test results as shown below:
beetween my TP-Link EAP and wireless device
and i also send speed test results by connecting to ISP modem directly
can you advise me how to check and configure step by step or other
Many Thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 825
Replies: 4
Voters 0
No one has voted for it yet.