Failover / Link Backup not working for IPv6?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Failover / Link Backup not working for IPv6?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Failover / Link Backup not working for IPv6?
Failover / Link Backup not working for IPv6?
2022-02-17 20:53:13
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2.0 Build 20220114 Rel.76871

Setup: I am using TL-R605 for failover with 2 ISPs, both running on its own router:

 

 

 

 

IPv6: I have configured IPv6 to passthrough for all 3 interfaces:





 



OK: Normally it is running on WAN2, I have this result testing with https://ipv6-test.com:

 

 

 

 

Fail: When I simulate failure of WAN2 by switching off router, IPv4 is switching to WAN1, but IPv6 stops running:

 

? Why is failover not switching IPv6, too? Is there another configuration necessary?

 

  0      
  0      
#1
Options
3 Reply
Re:Failover / Link Backup not working for IPv6?
2022-02-18 11:48:51

  @Farhampton 

 

As far as I know, this feature does not seem to work for IPv6 lol.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:Failover / Link Backup not working for IPv6?
2022-02-18 12:06:59

  @Virgo 

 

Should I write a feature request in the forum for this?

  0  
  0  
#3
Options
Re:Failover / Link Backup not working for IPv6?
2022-02-22 06:03:41

  @Farhampton 

 

Yeah, I think it makes sense.

Just striving to develop myself while helping others.
  0  
  0  
#4
Options