multiple CPE 710 AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

multiple CPE 710 AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
multiple CPE 710 AP
multiple CPE 710 AP
2022-02-15 14:01:28
Model: CPE710  
Hardware Version: V2
Firmware Version:

I have an exsisting Point to point CPE710, with basic configuration 192.168.0.254 for base AP, and 192.168.0.253 on client ap.

 

I am planning to add another CPE710 base AP back to back with my existing AP, will my ip be the same on 192.168.0.254 or differrent one the new CPE710.

Also can I use my old SSID and password? will it interfere or boost the signal strenght?

  0      
  0      
#1
Options
2 Reply
Re:multiple CPE 710 AP
2022-02-16 08:36:18

 Dear @Sigbin,

 

Sigbin wrote

I have an exsisting Point to point CPE710, with basic configuration 192.168.0.254 for base AP, and 192.168.0.253 on client ap.

I am planning to add another CPE710 base AP back to back with my existing AP, will my ip be the same on 192.168.0.254 or differrent one the new CPE710.

Also can I use my old SSID and password? will it interfere or boost the signal strenght?

 

Actually it is suggestion to change the IP of new CPE like change to 192.168.0.251, in case there is the IP conflict in the network.

And you can keep the SSID and password same as your old one, if you worry about the interfere you can change the CPE's channel to optimize the network environment.

 

Best Regards!

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#2
Options
Re:multiple CPE 710 AP
2022-02-22 13:29:55

  @Hank21  thank you for the support!

  2  
  2  
#3
Options