How to get the DHCP Client Name via SNMP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to get the DHCP Client Name via SNMP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EnzoConqueror

2022-02-10 13:50:20 - last edited 2022-02-11 00:55:44

Posts: 31

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-05-31

How to get the DHCP Client Name via SNMP

2022-02-10 13:50:20 - last edited 2022-02-11 00:55:44

Model: ER605 (TL-R605)

Hardware Version:

Firmware Version:

Hello TPLink Engineers

I am creating an application to monitor the network. I want to get all the client names connected to TL-R605 router via SNMP but I cannot find the right OIDs for it. I used MIBbrowser to walk but it cannot give the client names connected. Please see the screenshot below. I need to get this information in my application. Please help how to get these data from the router?

1 Reply

terziyski

LV7

2022-02-10 14:52:15 - last edited 2022-02-11 00:55:44

Posts: 6983

Helpful: 5199

Solutions: 1145

Stories: 7

Registered: 2013-10-12

Re:How to get the DHCP Client Name via SNMP

2022-02-10 14:52:15 - last edited 2022-02-11 00:55:44

@EnzoConqueror

The standard public OIDs are supported. What you're looking for is probably not implemented into the device FW. - check this thread.

Here are the supported public MIBs for TP-Link switches.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".

How to get the DHCP Client Name via SNMP

How to get the DHCP Client Name via SNMP

Information

Voters 0

Tags