Business Community > Controllers > Radios > Wi-Fi Modes
< Controllers

Radios > Wi-Fi Modes

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Radios > Wi-Fi Modes

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Radios > Wi-Fi Modes
Radios > Wi-Fi Modes
2022-02-01 15:51:36 - last edited 2022-02-02 09:42:34
Model: OC200  
Hardware Version: V1
Firmware Version: 1.14.3 Build 20220112 Rel.64116

 

When I was configuring the radios of EAPs, I found out I could not modify the Wi-Fi modes of each. I want to use only 11g/n modes because I don't have devices that use 11b.

User from SC to HC
  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Radios > Wi-Fi Modes-Solution
2022-02-01 20:06:32 - last edited 2022-02-02 09:42:34

@.Don 

 

Hey

 

This is achieved under RATE CONTROL on the SSID setup page..

 

Edit your wireless network and enable rate control as shown below.  Moving the 2.4ghz slider to the far right should disabled / stop B clients connecting

 

Recommended Solution
  2  
  2  
#2
Options
4 Reply
Re:Radios > Wi-Fi Modes-Solution
2022-02-01 20:06:32 - last edited 2022-02-02 09:42:34

@.Don 

 

Hey

 

This is achieved under RATE CONTROL on the SSID setup page..

 

Edit your wireless network and enable rate control as shown below.  Moving the 2.4ghz slider to the far right should disabled / stop B clients connecting

 

Recommended Solution
  2  
  2  
#2
Options
Re:Radios > Wi-Fi Modes
2022-02-02 08:23:34
Problem of this solution is that if you are connected further from AP you will be disconnected because you cannot reach higher than 54Mbps.
  0  
  0  
#3
Options
Re:Radios > Wi-Fi Modes
2022-02-02 09:38:01

@Philbert 

Oh, I see. I've seen this part used for creating wireless networks, but I didn't know its purpose. Thanks for the information.

User from SC to HC
  0  
  0  
#4
Options
Re:Radios > Wi-Fi Modes
2022-02-02 09:42:27

@Libik 

 

I did not really set mine to 54Mbps. I set mine to 12 Mbps.

I realized that disabling the CCK rates only removed the 1, 2, 5.5, and 11Mbps, so with this selected, I set the slider to 12 to completely disconnect devices behind that limit.

I have 3 EAPs anyway.

User from SC to HC
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 819

Replies: 4

Related Articles
EAP225 and Omada - Disable radios if disconnected
612 0
EAP690E HD 5GHz radios, why no 160MHz channel width?
719 1
 Omada controller does NOT actually turn the radios off !!!
809 1
 Controller master/slave modes
419 3
 EAP615-Wall(US) Rx Packet Loss on Radios
734 0
 Chaining two radios via the POE LAN port
835 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.