[OMADA SDN][BUG] UI bug in enabling the Managment interface on switch SG2210-MP.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TLDR: Cannot enable Managment VLAN on omada switches because of a UI bug. You can find a workaround at the end of the post.
Hello,
I think I found a bug in the Omada SDN web interface. I've connected a new SG2210-MP switch temporanely to a port and adopted it successfully. Before moving it to the final location, I want to set the management interface to a specific VLAN. If I try to enable the management VLAN by clicking the toggle button, a different section appears and disapperes (the IP address mode), see the following screenshots:
Moreover, for some reason, I must go to the Vlan config sections and from there go to the services tab, otherwise, the toggle button of management vlan does not appear:
As a workaround, I successfully changed the managment vlan by doing a "Batch Config", but I hope that this issue would be solved in the next release.
Thank you
best regards
Alex
