Home

Forums

Stories

Knowledge Base

Business Community > Switches > [SG2210P 4.0] set "ip management-vlan xxx"

< Switches

[SG2210P 4.0] set "ip management-vlan xxx"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[SG2210P 4.0] set "ip management-vlan xxx"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[SG2210P 4.0] set "ip management-vlan xxx"

Simon74

2021-12-27 11:32:57

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-12-27

[SG2210P 4.0] set "ip management-vlan xxx"

2021-12-27 11:32:57

Model: SG2210P

Hardware Version: V4

Firmware Version: newest

Hello,

How can I set the default vLAN for switch management? According to the CLI documentation the following command should be available, but it is not.

ip management-vlan xxx

When I remove the default network under L3 Interface, I only get to the switch from the default gateway, not from other subnets....

Thanks for Tips

ps. in other "T1500G-10PS 2.0" Switch is this very simple

2 Reply

Simon74

LV1

2021-12-27 12:35:05 - last edited 2021-12-27 12:38:17

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-12-27

Re:[SG2210P 4.0] set "ip management-vlan xxx"

2021-12-27 12:35:05 - last edited 2021-12-27 12:38:17

ok, my goal is reached.

I can now reach the Managament vLAN from all other subnets.
(Provided the firewall(10.8.250.1) allows this access).

Settings on the switch: (HVM-Management vLAN to Firewall-IP)

ip route 0.0.0.0 0.0.0 10.8.250.1

and disable Routing over GUI:

L3 Features\Interface\Routing Config -> Unchecked IPv4 routing

and:

L3 Features\Interface\Interface Config -> VLAN-ID DHCP 10.8.250.12 255.255.0 HVM Up

Fae

2021-12-30 03:21:01

Posts: 3613

Helpful: 1357

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:[SG2210P 4.0] set "ip management-vlan xxx"

2021-12-30 03:21:01

Dear @Simon74,

Simon74 wrote
How can I set the default vLAN for switch management? According to the CLI documentation the following command should be available, but it is not.
ip management-vlan xxx
When I remove the default network under L3 Interface, I only get to the switch from the default gateway, not from other subnets....

The command "ip management-vlan" is only available for older version.

For TL-SG2210P v3.20 and later version, you may use the command "user access-control" instead.

Check this CLI Guide for your TL-SG2210P v4 to get more details. Hope it helps.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

[SG2210P 4.0] set "ip management-vlan xxx"

[SG2210P 4.0] set "ip management-vlan xxx"

Information

Voters 0

Tags