TL-SG2428P v1 not initializing after reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG2428P v1 not initializing after reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG2428P v1 not initializing after reboot
TL-SG2428P v1 not initializing after reboot
2021-10-16 06:35:15
Model: TL-SG2428P  
Hardware Version: V1
Firmware Version: 1.1.1 Build 20210514 Rel.62941

My TL-SG2428P v1 wouldn't come back up after a routine reboot of device from the OC-200 Controller. Did a manual power unplug & then it stays with the PWR Led lit, does a full light up of all port LED's and then goes back to PWR Led and does not initialize further after that. OC 200 shows the device as disconnected. There was no other configuration change or new devices added from last restart.

 

Any troubleshooting suggestions here? It was perfectly functional had 17 POE Cams on them .. power drawn at last check was 74W total and all devices were functional. 

  0      
  0      
#1
Options
2 Reply
Re:TL-SG2428P v1 not initializing after reboot
2021-10-16 12:13:00 - last edited 2021-10-16 12:13:47

@darpamonkey 

 

What status show SYS led? this led should blink..

 

Do you have tried to reset the switch to default with reset button?

 

 I have similar switch but now I don't want try to reboot, have same software but never rebooted after software update.

 

Nice if you post the solution to this problem when you get one.

 

 

 

 

 

 

 

 

 

 

  0  
  0  
#2
Options
Re:TL-SG2428P v1 not initializing after reboot
2021-11-16 08:18:40

@darpamonkey 

 

Did you update the firmware of the switch? Does this happen after the update? 

 

 

Will it work after you power it off for some time? System seems to be down.. Power off for some time or reset may help. 

Yes. It's good to know if you have a solution or contacted TP-LINK.

  0  
  0  
#3
Options