OC200V1 compatibility with EAP235-Wall V1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

OC200V1 compatibility with EAP235-Wall V1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200V1 compatibility with EAP235-Wall V1
OC200V1 compatibility with EAP235-Wall V1
2021-09-24 09:50:25
Model: EAP235-Wall  
Hardware Version: V1
Firmware Version: 3.0.0

I have existing network of:

  • EAP225 V1/2 on Firmware 1.4.0
  • EAP245 V1 on Firmware 1.4.0 (3 of these)
  • EAP225-Wall V2 on Firmware 1.4.0

These are controlled by OC200 V1 on Firmware 1.2.3.  All works fine.

 

Have just bought EAP235-Wall V1 on Firmware 3.0.0.  AP works fine in stand alone mode but when I adopt to OC200, you cannot connect and the OC200 controller indicates that the Radio (both 2.4GHz and 5.0 GHZ) are not switched on.  I thought the EAP235-Wall was compatible with OC200 according to the TP_Link website.  Has anyone else experienced this?

 

I am now wondering if EAP235-Wall only compatible with latest firmware for OC200, but if i upgrade to that, I will lose ability to control all other APs.

 

Any advice gratefully received.

  0      
  0      
#1
Options
1 Reply
Re:OC200V1 compatibility with EAP235-Wall V1
2021-09-24 14:23:22

@JAC_123456 

 

Hey

 

I think you have the answer already, the new 235 Wall is a new device and therefore has no support for the SDN v3.x    You would need to update to SDNv4.x  (4.4.4 is latest)

 

However as you say the older 225 v1 and v2 are not compatible with the new SDN.   

 

Its either return the new 235 and go for the older model that is compatible, or upgrade the v1/v2 devices to v3 hardware and the OC200 to 4.4.4

 

Neither is really ideal sadly for you

  0  
  0  
#2
Options