i wana knw in which mode i do select to aces that free wifi? ? Sry frn if i have nt undrstnd. .i am trying frm 1 week bt i dnt get suces : (

i wana use that receive wifi by the lan . .

I all ready told you, what could be happening is that you have configure it many tinmes and could be over loaded with info. I advise you to factory default your CPE and start a fresh configuration, same one Universal repeater or Client both will give you internet by Lan cable, this one is for Universal repeater http://www.tp-link.us/article/?faqid=348 it reads How to configure TL-WA5110G/TL-WA5210G as a repeater but on step 3 you see it chooses Universal repeater, or you can use Client mode here http://www.tp-link.us/article/?faqid=318.
Dont forget to have your 5210 updated to latest firmware TL-WA5210G_V1_120821 here http://www.tp-link.com/en/support/download/?model=TL-WA5210G&version=V1#tbl_j
this is the third time on this thread I post you the same, if you do not get internet, on your next post. please post again from scatch what you want to do.

ok fren i will post it and is that update of 1mb only or it update by online>??

its a firmware update, download that file save it in your lap top, connect your 5210 via lan cable. here is a generic tuto for firmware update http://www.tp-link.com/en/article/?faqid=296

this tuto is a generic one for upgrading firmware http://www.tp-link.com/en/article/?faqid=296 its not online you download the file and save it in your lap top

LAN ip 192.168.1.1
default getaway 192.168.1.1
SSID :Digicom
Security :None this is the information of the WiFi router of digicom from where i wanna connect the net and use it as LAN.
hi fren i have done from the AP client mode as u said..and i have done the following step by step but i cant get success so here is the image that i capture step by step .at time of using signal is 11 db at range of 30..as in sayin to chanagae the ip adress after it dnt get laod .

please help :(

very low signal 7 dbs, but you are connected, and you can see it in Traffic Statics, the only thing left is, you are not setting back your lan adpater on your lap top to obtain ip address automatically and obtain DNS auto too, both have to be in auto, if you keep leaving it with static IP address you will need to add the Digicom gateway and DNS, thats the only mistake i see.

fren i have done all the setings and i put the dhcp server enable and put the exact the same no in which in digicom and in tplink wa5210g but fist time it says internet acess and later on it not acess and saying dns server is not responding..and that error ms apper in my windowa