How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
2021-08-21 20:42:32
Model: SG2210MP  
Hardware Version:
Firmware Version:

I am not an expert at networking and for sure not with Omada.  I'm learning about the Omada software as I go along.

 

I was wanting to know how I set my TL-SG2210MP switch to static ip using the OC200 controller?  I just can't seem to find the spot where it is located?  Is there a video, or a description some where that I am missing?  Thanks.

  0      
  0      
#1
Options
2 Reply
Re:How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
2021-08-21 21:48:42

@ingeborgdot 

 

Hey

 

Its easy enough to do, but a bit of a strange place

 

Go to DEVICES

 

select the SG2210MP

 

On the popup menu on right, go to CONFIG and VLAN Interface

 

You will see a list of VLANs, select the one your switch is registered on (likely LAN) and click the EDIT button

 

In there you can set the IP

  1  
  1  
#2
Options
Re:How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
2021-08-21 22:36:53 - last edited 2021-08-22 00:54:42

@Philbert I finally figured it out.  I actually did it from my phone.  It was easier to find in the app then on the PC.  So, I now have a static ip to the switch. Thanks.

  3  
  3  
#3
Options