VIGI NVR 1008H with HiLook Cameras

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VIGI NVR 1008H with HiLook Cameras

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VIGI NVR 1008H with HiLook Cameras
VIGI NVR 1008H with HiLook Cameras
2021-08-20 09:58:50 - last edited 2021-09-27 01:22:52
Model: VIGI NVR1008  
Hardware Version: V1
Firmware Version: 1.0.4

Hi all,

 

I am stuck with the configuration of this NVR. 

I have activated the cameras and assigned IP addresses via the SDAP took from Hik Vision. 

 

The VIGI system sees the cameras but whenever i add them, I have a green tick with '1 device added', then in the bottom window, "Connection Status: Not Connected".

 

What am i doing wrong here?

 

Are the HiLook cameras even compatible with the VIGI NVR?

 

 

Thanks,

Adrian. 

  0      
  0      
#1
Options
1 Accepted Solution
Re:VIGI NVR 1008H with HiLook Cameras-Solution
2021-08-30 11:59:23 - last edited 2021-09-27 01:22:52

@MrOizoNZ 

As far as I know, Hi-look is Hikvision camera, and normally, we should enable Onvif protocol on that camera, and create a admin account, then we can add them on NVR.

PS: Onvif is Open network video interface protocol.

Haha
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:VIGI NVR 1008H with HiLook Cameras-Solution
2021-08-30 11:59:23 - last edited 2021-09-27 01:22:52

@MrOizoNZ 

As far as I know, Hi-look is Hikvision camera, and normally, we should enable Onvif protocol on that camera, and create a admin account, then we can add them on NVR.

PS: Onvif is Open network video interface protocol.

Haha
Recommended Solution
  0  
  0  
#2
Options