How to keep EAP devices running if OC200 is off

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to keep EAP devices running if OC200 is off

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to keep EAP devices running if OC200 is off
How to keep EAP devices running if OC200 is off
2021-08-05 12:21:26
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.2

Hi every1,

 

  Is there a way to keep EAP wireless access points running, even with limited functionality, on an event that OC200 is off or looses connectivity ?

 

 

The UnF Networks, inc My TP-Link network : 1x OC200, 1x TL-R605, 2x EAP-245 & 1x TL-SG2008
  0      
  0      
#1
Options
2 Reply
Re:How to keep EAP devices running if OC200 is off
2021-08-06 02:30:30 - last edited 2021-08-06 02:36:39

@TheUnF 

 

It is running, actually. OC200 only runs the advanced features. Your wireless profile applied to the EAPs is working. Even it is offline. It is limited in functions. Basic wireless still exists.

 

Add: you need EAPs to have power and Internet. They'll work

  0  
  0  
#2
Options
Re:How to keep EAP devices running if OC200 is off
2021-08-06 14:07:54

@Yannie 

 

Well, during a recent bad cable management, only the OC200 went down but some minutes later all EAP drop their radios and did not came back until I power on the OC200 back again.

 

I had to go wired on the same switch that the EAP were connected to pass thru the ER605 and reach the internet.

So power and internet connectivity were not the issues to the EAPs went down.

 

Is there any config that prevent this, OR which config should be causing it ?

 

 

The UnF Networks, inc My TP-Link network : 1x OC200, 1x TL-R605, 2x EAP-245 & 1x TL-SG2008
  0  
  0  
#3
Options