Home

Forums

Stories

Knowledge Base

Business Community > Routers > TLR605 Load balancing issue

< Routers

TLR605 Load balancing issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TLR605 Load balancing issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Satran

2021-07-20 05:25:17 - last edited 2021-07-20 05:36:32

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-07-16

TLR605 Load balancing issue

2021-07-20 05:25:17 - last edited 2021-07-20 05:36:32

Model: ER605 (TL-R605)

Hardware Version: V1

Firmware Version: 1.0.1 Build 20210113 Rel.35074

I configure my TL-R605 router with 2 WAN links. Fist link is 300 Mbps and unlimited data and 2^nd link is 100 Mbps and data limit is 200 GB. I have enabled load balancing also. My problem is more data is following in 2^nd link and the data limit will over very fast. I have reset the router and interchange WAN links and reconfigured but every time 2^nd link is utilizing more. Is there way can we give preference to 1^st link.

Firmware Version :1.0.1 Build 20210113 Rel.35074

3 Reply

John1234

LV4

2021-07-21 07:37:10

Posts: 502

Helpful: 67

Solutions: 12

Stories: 0

Registered: 2021-05-21

Re:TLR605 Load balancing issue

2021-07-21 07:37:10

@Satran

Would you please share the setting on the "Load Balancing--Basic Setting"? Did you enable the option “Bandwidth Based Balance Routing” and set up the Upstream/Downstream Bandwidth?

Satran

LV1

2021-07-21 08:29:12

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-07-16

Re:TLR605 Load balancing issue

2021-07-21 08:29:12

@John1234

Before I have not selected any think. Now I have selected as below. After selection now more data is flowing through 1st link. Thanks.

But now I am getting only 1st link B/w i.e 300 MBps.

Landcruiser

LV1

2021-07-22 08:15:47

Posts: 13

Helpful: 4

Solutions: 2

Stories: 0

Registered: 2021-01-03

Re:TLR605 Load balancing issue

2021-07-22 08:15:47

@Satran

Point 1.

The traffic statistics shown by R605 is not correct. It is known issue reported in this forum and also acknowledged by TP-Link. You can search the forum for that particular issue.

Point 2:

Since we cannot rely on the R605's statistics, we have to rely on either the IPS data or other information.

TLR605 Load balancing issue

TLR605 Load balancing issue

Information

Voters 0

Tags