oc200/eap620: see ssid but no internet access
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
oc2oo/eap620: staff can see ssid, but have no access to internet.
Hi,
bought t2600g-28ts 4.0, oc200 and eap620. Unfortunately, Tp-link switch is not compatible with oc200/eap620 (thanks to the vendor !). Set up oc200 behind firewall and from different subnet is difficult.
Then, I decide to setup oc200/eap620 like this :
Router
Firewall (opnsense)
Port 3 (firewall) : Linksys (for something like IOT)
Port 2 (firewall):
Netgear POE GS308P
-> OC200
-> EAP620 (Power AC220V)
OC200 is related to EAP and I have full access to dashboard oc200/eap
From different Vlan, I have full access to dashboard oc 200/eap
(Note : I do not want a cloud access)
Port 3 has access to internet (no blocking firewall rule)
Dashboard shows :
wired network >LAN>192.168.0.1/ 24
no wan
Network analysis shows :
192.168.xx.100 (http, Omada Controller -Jetty 9.4.15v20190215)
192.168.xx.101 (probably eap ip address)
and a microsoft surface get the following ip : 192.168.xx.4
Perhaps, it's a ip misconfig?
Where can I configure the wan ip for oc200/eap620 ?
Where can I configure the dhcp server for the wifi connections ?
Thanks
Any assistance much appreciated!
First time, i use tp-link
I double check the firewall opnsense 21.1.8_1 Dec
Interface firewal opnsense : igb3 wifi
static ipv4 adress lets say 192.168.50.254
service
dhcpv4 : enable
subnet 192.168.50.0
DNS okip
Enable Static ARP entries
Surface (w10) connected to wifi
dhcp automatique
192.168.50.4
DNS okip
Macbook connected to wifi
192.168.50.1
Firewall DHCPV4 Lease
mac/ip surface correct (active)
mac/ip mac correct (active)
mac/ip oc200 correct (static)
mac/ip eap 620 correct (static)
oc200/eap620
Controller Version:
4.3.5
Model:
OC200 1.0
Firmware Version:
1.8.0 Build 20210406 Rel.58757
test mail server correct (This is a message generated by Omada SDN Controller [OC200_58F9DB].
Getting this message means that your SMTP server settings are correct.)
At this time : no vlan. No mac filtering. Just a try. First image : is this the problem ? (and how to correct?)
Other screenshots:
thanks for your hints