I have 2x EAP235-Wall and 1 EAP265 HD and an OC200 controller.

The EAP235's are hard wired, and I am attempting to get the eAP265 setup in a mesh configuration.

Followed the TP link guide, and allow the controller to detect the EAP265 following the guide. But I wasn't able to get it to work.  The controller simply does not see the EAP265 after powering it on.  I was assuming that the EAP235-wall units don't support mesh and that I'd need to pick up another EAP265 and swap one of the wall units out. Can't find any documentation if my assumption is correct though.  Puling out my hair, please help.