Pharos CPE510 unstable connection
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have a client with a camping site. We installed 10 EAP 225 outdoor acces points in mesh mode, with 2 wired ap's. This is controlled by an omada controller. To reduce the wireless connections and hop's in the mesh configuration we installed a point-to- point connection between 2 CPE 510 devices. One is acting as a client and the other as a AP. There's a router in the network with dhcp and both CPE510's have a fixed ip (192.168.0.50 and 192.168.0.51, dhcp starts above 100). On the POE injector of the receiving CPE (client) there is a EAP 225 outdoor connected with a POE adapter. I am able to establish the connection between the two cpe device and everything looks fine (screenshot of client) but after a while (sometimes hours, sometimes a day) the connection is lost between the two cpe devices. When i restart the AP cpe the connection is then again established for a while but almost every day the connection is lost. the distance between the two CPE devices is about 230 meters (on the cpe devices it indicates with auto measure 264 meters). How can i detect the problem of the lost connections? (the AP CPE is wired to a gigabit switch who is connected to the modem/router)
