Omada Controller oc200 / TL-R605 (DHCP and VLAN's problem)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Omada Controller oc200 / TL-R605 (DHCP and VLAN's problem)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I had big problem when I configure AP's to work with oc200 and TL-R605 (using manual IP, mask, gateway and DNS addresses).
In this configuration I used tp-link switches but not dedicated for Omada. With my old router/firewall everything worked fine.
With TL-R605/oc200 clients only receive IP address from controller/router in VLAN's when AP's is configured to have automatic DHCP.
If you change this to your manual settings, DHCP don't pass IP to clients.
After this, if you even change back from manual to automatic DHCP settings - still are not working.
Finally,
After I deleted interface profile for VLAN, and add it again, AP started working with random IP numbers from LAN (of course AP's must be in automatic DHCP mode)
Maybe somebody find this helpful...
Best regards,
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 8140
Replies: 11
Voters 3
