EAP660 / WPA Authentication Timeout/Failure
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.EAP660 / WPA Authentication Timeout/Failure
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have both an EAP225-Outdoor and just got an EAP660HD. I had hoped to use the EAP660HD to replace an aging Airport Extreme, however when I disconnect the Airport to let the EAP660HD hande the majority of my home wireless traffic, many of the IoT devices fail to associate with that AP. I see "WPA Authentication Timeout/Failure" accumulating in the Omada console. I have had to resort back to my Airport Extreme for those devices.
The devices that fail to associate are majority IoT devices - many based in the ESP32 processor series runing Tasmota firmware (though many other IoT devices are also not associating).
Is there a setting I can change? The network is only IP4 and IP addresses are giving out via a Ubiquiti Edge device.
thanks,
...tom
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @tpe,
I agree the EAP660HD and firmware are very new. I'd suggest returning it and getting a EAP225V3 for $59 from Amazon to tide you over for the next 6-12 months.
While I'd like to upgrade to the EAP660HD myself, I'm not going to pay $250+ for each of them.
-Jonathan
- Copy Link
- Report Inappropriate Content
I have the same issue for months. I have contacted the supplier and TP-Link but no answers so far. Really intrested way this happens.
What I have noticed myself.
- Switching of Force-Disassociation will reduce the amount of error. But does solve it
- Multiple devices are impacted. Most when they are in the same are
- Moving a EAP660 close to this area (so signal strength is not an issue) will not solve it.
Any help is appreciated
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 5552
Replies: 12
Voters 0
No one has voted for it yet.