lan wan balance router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello, thanks to anyone help me and I hope to explane as well what I need, sorry for my english.
Dubts on ip addresses.
I have two internet connections Router WAN1 ip 192.168.1.1 and Router WAN2 192.168.1.2 (in this I cannot change ip address).
Router WAN1 is the default gateway on all my pcs (all pcs have static ip), so Router WAN2 is not used.
I think to buy TL-R470T+ Balance router (then I call it ROUTER) and use both WAN1 and WAN2.
Questions:
1. can I use for ROUTER 192.168.1.3 ip? (then I'll change on all my pcs default gateway from 192.168.1.1 to 192.168.1.3)?
2. if not possible question #1, if I set ip ROUTER 192.168.0.3, can I set default gateway ip 192.168.0.3 on my pc with ip 192.168.1.4? Does that pc use internet then?
Hey again
Hopefully this will help
if some clients try to use UPD or TCP port 5060 I need to use WAN2
You need to go to preferences > service type and create a new service for the ports you need (see below)
You can then go to TRANSMISSION > ROUTING > POLICY ROUTING and create a profile to move the new service you created above.. to the WAN2 Port. Again example below.
----------------
if some clients try to connect to (example external ip address) 123.123.123.123 ip address I need to use WAN2
Try setting a static route for the IP via WAN2, example below
The next hop would likely be the router address, however I have not tested this.. you may need to play around to get this working