Edit: Apologies, i see that this problem has been reported multiple times already as seen here:

https://community.tp-link.com/en/business/forum/topic/246314

https://community.tp-link.com/en/business/forum/topic/245372

https://community.tp-link.com/en/business/forum/topic/245290

Hopefully this can be fixed soon

                                                                                                               ​​​​​​​                                                  

Original Post:

I just added the TL-R605 Router to my home network, but now the clients list in SDN keeps most of the clients bouncing from Wireless to Wired connection, one minute, there is about 30 wireless client, which is correct, then the next minute, those 30 clients will report as being connected wired.

When looking at the event logs, i can see the clients constantly being disconnected from "LAN" on the R605 and connecting to a wireless access point (EAP245v3), then looping again.

My setup is as follows:

                                                                                                |---> Misc wired clients

Modem ---> (WAN) TL-R605 (LAN)---> Unmanaged Switch |---> Software Controller

                                                                                                |---> x3 EAP Access Points

Am i doing something wrong? What's throwing me off is that it does show correctly occasionally, but then it'll change within minutes to having most clients connected on Wired as opposed to Wireless. It's annoying because i cannot monitor the signal strength of the clients and monitor whether they are roaming correctly as they will often show as connected via wire in SDN. I'm open to suggestions, any help wold be appreciated.