TL-R605 trunking

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R605 trunking

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R605 trunking

Tyrant1919

2020-12-29 04:34:28

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-29

TL-R605 trunking

2020-12-29 04:34:28

Model: ER605 (TL-R605)

Hardware Version: V1

Firmware Version: 1.0.0 Build 20200930 Rel.36519

I'm in the middle of migrating to the TL-R605 from an edge router. I'm unable to properly configure the LAN port to utilize 802.1q trunking. I have a cisco 3560 setup for trunking to the LAN port on the TL-R605. I have 3 interfaces configured under Wired Networks > LAN in Omada 4.2.4. Only the default interface I can't delete works. How to I setup tagging on the LAN interface to get this to work? I do not think I can configure trunking with the cisco switch using Omada 4.2.4.

1 Reply

Fae

2021-01-04 09:57:40

Posts: 3613

Helpful: 1357

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:TL-R605 trunking

2021-01-04 09:57:40

Dear @Tyrant1919,

How to I setup tagging on the LAN interface to get this to work? I do not think I can configure trunking with the cisco switch using Omada 4.2.4.

After you configure Interface for the specific LAN port under Wired Networks > LAN in Omada V4.x, the corresponding LAN port of the TL-R605 will be trunk. For the Cisco switch, it cannot be managed by the Omada Controller, you may configure turnk with its own management tool.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

TL-R605 trunking

TL-R605 trunking

Information

Voters 0

Tags