Cannot connect CPE 210 - IP Address is used by modem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-12-14 16:09:45

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-14

Cannot connect CPE 210 - IP Address is used by modem

2020-12-14 16:09:45

Model: CPE210

Hardware Version:

Firmware Version:

I cannot access or communicate with the CPE as my modem uses the 192.168.1.254 port for internal use.

This is the response from an IP Scanner.

How can I do? Can the IP of the CPE be changed?

Marcello

1 Reply

2020-12-18 06:15:43

Posts: 3603

Helpful: 1360

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:Cannot connect CPE 210 - IP Address is used by modem

2020-12-18 06:15:43

How can I do? Can the IP of the CPE be changed?

The default IP of Pharos CPE is 102.168.0.254. You can change it to fit into your network from its web management page.

To access the Pharos CPE, you may need to hardwire the CPE directly to your PC and configure static IP first.

Please refer to the setup video below to log into the CPE web management page and then configure it.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*