TL-R605 not visible in Dashboard and Speedtest loop
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R605 not visible in Dashboard
Speed test loops, after 240 it start again
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
I have the same problem, mobile phones are displayed alternately as lan / wifi https://community.tp-link.com/en/business/forum/topic/245372?page=1
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Anconakip
Could you please open a seperate discussion for this? The current one is regarding the router and the speedtest loop.
Kind regards,
Robert
- Copy Link
- Report Inappropriate Content
@Fae Any update on when the update will become available?
- Copy Link
- Report Inappropriate Content
I am also having the same problem and would like to know when the fix will be released.
- Copy Link
- Report Inappropriate Content
Hi all,
Regard with the Speedtest issue, the R&D team will fix it in the next version, but sorry that I don't know when the update will be released.
I will start a new thread and pin it to the top in the block of Omada Cloud SDN once the Omada SDN Controller has newer firmware to be released. Then you can check for the update to fix the problem.
As for the issue that is similar to this topic Wireless Clients showing as Wired in SDN, the developer team is checking it, I will share the info in this post once there is a solution. If you find a new problem in the future, please feel free to start a new thread to discuss it. Thank you!
- Copy Link
- Report Inappropriate Content
I can tell that the speed test now works perfectly, only it still says that there are 0 switches online.
- Copy Link
- Report Inappropriate Content
Dear @Lowie,
Please kindly note that the TL-R605 is the Gateway, not a Switch.
Is there an Omada SDN Switch existed in your network?
- Copy Link
- Report Inappropriate Content
Okay then I misunderstood that, I thought you would see the gateway there too.
Because if you click on the switches icon you will see the 605 online.
And I don't have Omada supported switches in the network.
So as I understand it now it is correct.
- Copy Link
- Report Inappropriate Content
@Fae The new version 4.2.11 displays the gateway now. I tested this yesterday.
But this morning It was not there anymore. I had to do a manual speed test again to see the gateway again.
It did not remember the gateway. Is there a setting for this? How frequent will the controller perform a speed test on it's own?
Kind regards!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 27934
Replies: 56
Voters 1
