New help setting-up a dual WAN TL-ER6120 router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I would need help to configure my TL-ER6120 router.
How do you set routes to send/receive traffic to a specific WAN interface ?
I know it's a basic question...
Thanks for the help.
Andrew
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Andrew_Hobson,
How do you set routes to send/receive traffic to a specific WAN interface ?
We can only set to make certain traffic go through specific WAN with Policy Routing function.
Here is the instruction for your reference. https://www.tp-link.com/support/faq/530/
- Copy Link
- Report Inappropriate Content
Hello,
Thanks for your help.
Here is what I would like to do.
I would like to isolate 2 devices on my network and put them apart in a specific VLAN and make them use WAN2 on the TL-ER6120 router.
All the other devices on the network can use VLAN1 and go thru WAN1.
Would this be possible with the TL-ER6120 v1 ?
Thanks for your reply.
Andrew
- Copy Link
- Report Inappropriate Content
Dear @Andrew_Hobson,
I would like to isolate 2 devices on my network and put them apart in a specific VLAN and make them use WAN2 on the TL-ER6120 router.
All the other devices on the network can use VLAN1 and go thru WAN1.
Would this be possible with the TL-ER6120 v1 ?
The TL-ER6120 V1 supports Port VLAN which allows you to create VLANs among the LAN ports based on their port numbers. If you want to isolate the LAN devices based on LAN ports, you may configure Port VLAN.
But the router doesn't support to make a certain VLAN (based on Ports) go thru a specific WAN, we can only make certain devices (based on IP address) use a specific WAN with the policy routing rules.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 724
Replies: 3
Voters 0
No one has voted for it yet.