fourth ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

fourth ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
fourth ap
fourth ap
2020-09-25 13:55:00
Model: EAP225-Outdoor  
Hardware Version:
Firmware Version: 4.1.5

using omada cloud controller, successfully added 3 eap225 outdoor. trying to add fourth, the ap defaults to 192 address but shows up, when i try and adopt it fails. if i unplug one of the other 3 and plug fourth in, it gets correct address and i can adopt it. i cannot get a fourth ap to adopt. any suggestions?

  0      
  0      
#1
Options
2 Reply
Re:fourth ap
2020-09-25 17:02:39

@texas46rv, perform a hard reset on the fourth AP to load factory defaults (press the RESET button and hold it for ~7 seconds until the LED flashes green-yellow-red) and try again to adopt it. You can also read this recipe what to do if an EAP can't be adopted: https://community.tp-link.com/en/business/forum/topic/164118

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:fourth ap
2020-09-27 09:54:58

Dear @texas46rv,

 

using omada cloud controller, successfully added 3 eap225 outdoor. trying to add fourth, the ap defaults to 192 address but shows up, when i try and adopt it fails.

 

How do you power up the 4 EAP225-Outdoor, via provided PoE injector or via a PoE switch?

When you notice the AP shows up with default 192.168.0.254 on the controller, it means the EAP is failed to obtain an IP address from the DHCP server in the network, please ensure the EAP is well connected to the network via a working cable, and verify the DHCP IP pool is not overloaded.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options