CPE610 Wireless Signal Quality Empty.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE610 Wireless Signal Quality Empty.
Model:
Adapter
Hardware Version: V3
Firmware Version: Last
Hello, I have a cpe610 device. Wireless appears in the survey, but values are not shown in the chart. It was not like this before, this problem has just begun. I've been waiting for 5 hours.
Re:CPE610 Wireless Signal Quality Empty.
Dear @Jackwein,
From the screenshots of the Status page, it seems the CPE610 in Client mode is not connected to the root AP at all.
You may refer to Part I: Troubleshooting about CPE_Client cannot connect to the CPE_AP from the guide below to try some troubleshooting.
How can I set up the AP + Client topology successfully
In addition, why you use Feed Only mode for the Antenna? How far is the Client CPE away from the root AP? Do you use a second CPE610 V2 as the Root AP?
>> Omada EAP Firmware Trial Available Here <<
*Try filtering posts on each forum by Label of [Early Access]*