Switch TL-SG1016PE won't enable ports!

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Switch TL-SG1016PE won't enable ports!

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

reper

2020-08-13 11:43:46 - last edited 2020-08-13 11:45:12

Posts: 1

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2020-08-13

Switch TL-SG1016PE won't enable ports!

2020-08-13 11:43:46 - last edited 2020-08-13 11:45:12

Model: TL-SG1016PE

Hardware Version: V1

Firmware Version: 1.0.1 Build 20190118 Rel.32996

We have two switches TL-SG1016PE both V1 rev., with the latest firmware version 1.0.1 Build 20190118 Rel.32996.

All ports are enabled. They both have a link problem even after hard reset. If i connect pc or any other device to another port during work link cannot established. When i revert cable back to first port its connecting succesfully. It seems a switch checks ports only at start. WTF TP-LINK???

1 Reply

Fae

2020-08-14 03:30:30

Posts: 3603

Helpful: 1360

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:Switch TL-SG1016PE won't enable ports!

2020-08-14 03:30:30

Dear @reper,

If i connect pc or any other device to another port during work link cannot established.

Do you mean that the corresponding Ethernet LED indicator is OFF on the SG1016PE switch?

If it's the case, please follow this guide to test the switch. Thank you in advance.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

Switch TL-SG1016PE won't enable ports!

Switch TL-SG1016PE won't enable ports!

Information

Voters 2

Tags