new software controller V4.1.5
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After upgrading to new controller supporting SDNeverything worked fine, all EAPS were working fine, now EAPS show disconnected, the controller states the EAP needs an Firmware upgrade but the eap is already on the latest firmware. No addoption possible. Please help.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
PhilipH wrote
now EAPS show disconnected
Check connectivity between EAPs and the controller. If EAPs can't reach the controller, they will change into Disconnected state.
the controller states the EAP needs an Firmware upgrade but the eap is already on the latest firmware.
No, it's not at latest firmware. Latest firmware for EAP245 V3 is v2.20.0. The controller states correctly that the EAP needs to be upgraded. You can do so when EAPs change to Connected state again (that means when you could re-establish a network connection from EAPs to the controller again).
Did you read the Omada Controller Upgrade Guide before upgrading?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
PhilipH wrote
when i reboot all eaps are in a disconnected state again.
Uhm, when you reboot what? The machine running Omada Controller? Of course the EAPs will be disconnected then! You did disconnect the controller from the EAPs when rebooting the server or shutting down the controller. Just wait until the EAPs sync with controller when restarting it. No need to re-install the controller software again to just have EAPs re-connect to the controller. They do so automatically.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1157
Replies: 4
Voters 0
No one has voted for it yet.