[REGRESSION] Omada SDN Software Controller 4.15 / Scheduler can no longer be tied to individual APs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
With Omada Controller 3.x it was possible to create a schedule which is bound to an AP instead of a wireless network.
This way I turn off certain APs inside the house during the night without turning the wireless network off completely.
With 4.1.5 this functionality is lost and I can only turn off entire wireless networks.
Please consider restoring this functionality as this is significant regression in flexibility.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
ASCII wrote
With Omada Controller 3.x it was possible to create a schedule which is bound to an AP instead of a wireless network.
This way I turn off certain APs inside the house during the night without turning the wireless network off completely.
With 4.1.5 this functionality is lost and I can only turn off entire wireless networks.
Please consider restoring this functionality as this is significant regression in flexibility.
This will be forwarded as a feature request to our developers for consideration. Thank you again for your feedback.
- Copy Link
- Report Inappropriate Content
@Fae Thank you
- Copy Link
- Report Inappropriate Content
Dear TP LINK,
I love the new controller but comptablity is a major issue. We purchased our Access Points from Amazon a few years ago. Not more then 2-3 years. I have EAP 330 & EAP 245 and invoice going back as far as 2018. Removing support and funtionality for products that short is very diffcult, I am sure many orgzantaions who have these APS will be forced to update them because they have no option. The upgrading process was very diff, it was not plug and play and adopt. I had to connect it and update the frimware before it would even adopt the AP. this is the latest V3 from Amazon. I do not like running legacy or older hardware. Please provide better options and paths or at least a upgrade progam. Now I have multiple APS that will need to be upgraded and be tossed and not used.
Thank You
- Copy Link
- Report Inappropriate Content
NETWORKENG wrote
The upgrading process was very diff, it was not plug and play and adopt.
The upgrade process for supported EAPs is very easy if you obey the order of migrating/upgrading the controller before upgrading the EAP firmwares.
See this post how it can be done in just a few minutes using batch upgrade.
Note that when migrating the old controller to the new one, EAPs will already appear as »Connected« in the new controller even if not yet running the new firmware. Nothing more to be done except a batch upgrade of the EAP's firmwares.
In the post linked to above I did set up the SDN controller from the very beginning, so I had to adopt the EAPs running the old firmware. In this case one either needs to make note of the old device account or to set the device account in the old controller back to »admin/admin« while the EAPs are still being managed by the old controller. Alternatively, EAPs can be reset to factory defaults and will be configured as soon as they are adopted in the new controller.
In my opinion, the upgrade path to the SDN Controller couldn't be any easier.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 1385
Replies: 6
Voters 1