EAP 225 Always on Same Channel

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP 225 Always on Same Channel

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Soxcks

2020-07-14 02:43:02

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-07-14

EAP 225 Always on Same Channel

2020-07-14 02:43:02

Model: EAP225

Hardware Version: V2

Firmware Version: 1.4.0 Build 20180323 Rel. 32579

I have 2 access points in my house. I'd like to set them to automatically adjust channels, but to be on separate channels. For example, if (on the 2.4GHz spectrum) one AP is on Channel 1, the other AP should be on channel 6 or 11. If either AP has to switch it's channel, it would switch to a channel that the other AP is not on. Is this possible?

1 Reply

Fae

2020-07-14 03:25:20

Posts: 3613

Helpful: 1355

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:EAP 225 Always on Same Channel

2020-07-14 03:25:20

@Soxcks

Hi,

Soxcks wrote

I have 2 access points in my house. I'd like to set them to automatically adjust channels, but to be on separate channels.

For your requirement, it's suggested to manually select different channels for each AP.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

EAP 225 Always on Same Channel

EAP 225 Always on Same Channel

Information

Voters 0

Tags