Failover

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Failover

2020-07-11 22:45:39 - last edited 2021-04-19 10:56:53

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-07-11

Failover

2020-07-11 22:45:39 - last edited 2021-04-19 10:56:53

Model: TL-R480T+

Hardware Version: V9

Firmware Version:

Failover not working primary wan up but failover use backup link

How to manage this issue?

1 Reply

2020-07-13 06:46:37 - last edited 2021-04-19 10:56:53

Posts: 3603

Helpful: 1360

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:Failover

2020-07-13 06:46:37 - last edited 2021-04-19 10:56:53

Hi,

Aadil786 wrote

Failover not working primary wan up but failover use backup link

How to manage this issue?

Firstly, please ensure you configure the Link Backup function correctly.

Enable Load Balance must be enabled if you want to configure Link Backup. Otherwise Link Backup won’t work normally.

Secondly, the Link Backup function is based on the testing result of online detection.

To get an accurate testing result, we suggest you choose the manual mode and configure the destination IP address by yourself.

If you still have trouble, you can post some pictures of your configuration so that we can check it together.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*