CPE CLIENT TO EAP OUTDOOR

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE CLIENT TO EAP OUTDOOR

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE CLIENT TO EAP OUTDOOR
CPE CLIENT TO EAP OUTDOOR
2020-06-25 07:13:45
Model: CPE510  
Hardware Version:
Firmware Version:

I have made CPE Access point to CPE client mode and internet connection is access in my computer. When I connected with eap225 outdoor, can't adopt in omada controller. 

I also try to reset this ap. But can't adopt. I also made dhcp in client CPE. But can't sloution this issue.

When i connected with exiting mesh network, it can be adopted. How can do it?

  0      
  0      
#1
Options
3 Reply
Re:CPE CLIENT TO EAP OUTDOOR
2020-06-25 07:31:56

@nyinyihan, the EAP uses its default fall-back IP 192.168.0.254 and this is the reason that you cannot adopt it.

 

If you set up a DHCP server on the CPE, you need to reboot the EAP to force it requesting an IP over DHCP.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:CPE CLIENT TO EAP OUTDOOR
2020-06-25 12:06:13
I set up without dhcp. But can't adopt.How to solve this?
  0  
  0  
#3
Options
Re:CPE CLIENT TO EAP OUTDOOR
2020-06-25 21:35:53 - last edited 2020-06-25 21:36:29

@nyinyihan, you need to set the IP of the EAP before it can  be adopted.

 

Either try to set a static IP in the EAP's web UI and then adopt it (should work with latest firmware according to TP-Link) or use DHCP to assign an IP to the EAP.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options