1
Votes

Ability To Disable Firewall Access Rule Without Delete

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
1
Votes

Ability To Disable Firewall Access Rule Without Delete

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Ability To Disable Firewall Access Rule Without Delete
Ability To Disable Firewall Access Rule Without Delete
2020-06-17 12:27:36
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version: 4.0.4 Build 20200313 Rel.41831

It would be convenient to be able to disable a firewall access rule without deleting it. I have rules that are normally not enabled, but I would like to have the rule listed to enable at any given time. Since most of these rules are allowing specific traffic, I plan to change the policy to BLOCK until I need them. It would still be nice to have a Status column on the Firewall's Access Control List page to be able to Enable/Disable a rule similar to the VPN's IPsec page.

 

  Thanks

#1
Options