Can't Connect to switch via GUI
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I just replaced an 8 port switch with a new TP-Link 16 port JetStream but am unable to access the GUI via browser, or any other means for that matter.
Anybody else have the same problem or any suggestions how to access? The switch works but I am unable to program.
My routers IP is 192.168.xxx.01. My pc has similar IP as router but when I type 192.168.01, I get the message "Can't reach this page."
The switch uses the IP address of 192.168.0.1 by default. I suggest to remove the switch from the network. Then connect a PC to the switch. Set static IP adderss for your PC like 192.168.0.2/24, then access the switch through type 192.168.0.1 on browser.
After access the management web of switch, suggest to change the IP address then connect the switch back to netiwork. Change the IP address in the following interface.
