Data and Voice VLAN need to get in SG2210 Swith
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
Connected my TP link switch with a cisco switch through SFP connectivity. Fiber Link showing blinkining.
I have voice and data VLAn available in Cisco core switch.Created the same number VLAN in TP link also.But no communication happening either phone or System
How I will get the communication through this switch
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Did you configure the SFP port as tagged member of the VLANs in question? On both switches?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Are you talking about T1500G-10PS or TL-SG2210P? Does your switch connected directly to your core switch? Both sides LEDs blinking? Provide 'show run int gi1/0/x' of both switches.
- Copy Link
- Report Inappropriate Content
I created one server VLAN which resides in Core Switch. Tagged the SFP ports on all VLAN.
Changed the ports PVST to given the specific VLAN ID and gets the ip address from those VLAN.
So I am getting one VLAN from specific ports and I am able to communicate to only that VLAN
How I can get both VLAN in single ports with PVST settings
- Copy Link
- Report Inappropriate Content
Well, you are talking about PVST (Per-VLAN Spanning Tree) and you are talking about some VLAN blocking. Obviously, it is a question to your PVST setup. TP-Link doesn't support PVST, only MSTP, so you should reconfigure your cisco. Still it is unclear without full topology, because before you talked only about 1 link and now there is some topology with rings, etc, to be blocked. You need to change your Priority/Path Cost/etc.. to unblock VLANs on this link.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1602
Replies: 5
Voters 0
No one has voted for it yet.