Business Community > Requests & Suggestions > UTILISING AN EAP110 FROM A T2600G-28MPS POE+ SWITCH BUT UNIT WONT POWER ON
< Requests & Suggestions
 
0
Votes

UTILISING AN EAP110 FROM A T2600G-28MPS POE+ SWITCH BUT UNIT WONT POWER ON

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
0
Votes

UTILISING AN EAP110 FROM A T2600G-28MPS POE+ SWITCH BUT UNIT WONT POWER ON

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
UTILISING AN EAP110 FROM A T2600G-28MPS POE+ SWITCH BUT UNIT WONT POWER ON
UTILISING AN EAP110 FROM A T2600G-28MPS POE+ SWITCH BUT UNIT WONT POWER ON
2019-07-02 19:07:31

Hi, just new to the forum.

 

Could anyone with the knowledge help me out, I have a T2600G-28MPS POE+ switch deployed in my home, it currently has a few IP Cameras and a few PC's plugged into it, all working fine.

 

I was hoping to deply an Access Point (EAP110) in my back garden as we have no Wifi Signal there, but i would rather not use the POE injector supplied, am i missing something simple here as it wont power up when i plug it into the switch.

 

Notes:

EAP110 Works fine with an Injector

Tested the Switch Port with a Camera and it operates

 

Any help would be appreciated.

 

Phil

 

#1
Options
1 Reply
Re:Re:UTILISING AN EAP110 FROM A T2600G-28MPS POE+ SWITCH BUT UNIT WONT POWER ON
2019-07-31 23:26:47

Thanks for this Questionmark, should of joined the forum and researched it before the purchase, have it running through the injector getting 70mb signal in the Garden.

 

Its more than exceeded expectations.

 

Will take note about the wireless section.

 

Thanks again

 

 

#3
Options

Information

Helpful: 0

Views: 946

Replies: 1

Voters 0

No one has voted for it yet.

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.