Home

Forums

Stories

Knowledge Base

Business Community > Routers > After updating the firmware do not access the firewall.

< Routers

After updating the firmware do not access the firewall.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

After updating the firmware do not access the firewall.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Alex.RSG

2019-06-18 16:28:52 - last edited 2021-04-19 12:08:33

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-06-06

After updating the firmware do not access the firewall.

2019-06-18 16:28:52 - last edited 2021-04-19 12:08:33

Model: TL-R480T+

Hardware Version: V5

Firmware Version:

Hello guys, after updating the firmware of the TL-R480T + I can no longer access it.

I tried to perform a manual reset, but it is not resetting, the LED SYS does not blink.

I tried to connect the notebook directly but all the connections are disabled (tested on all ports).

What can I do in this case after all these tests?

3 Reply

Mitya

LV4

2019-06-19 15:57:48 - last edited 2021-04-19 12:08:33

Posts: 310

Helpful: 74

Solutions: 9

Stories: 0

Registered: 2018-08-09

Re:After updating the firmware do not access the firewall.

2019-06-19 15:57:48 - last edited 2021-04-19 12:08:33

Just go to serivce-center, nothing you can do.

Andone

LV4

2019-06-20 01:04:49 - last edited 2021-04-19 12:08:33

Posts: 747

Helpful: 115

Solutions: 18

Stories: 0

Registered: 2018-07-19

Re:After updating the firmware do not access the firewall.

2019-06-20 01:04:49 - last edited 2021-04-19 12:08:33

Press the reset button for 4-6 seconds. Wait for the router reboot automatically. If still cannot reset he router and SYS LED doesn't blink, maybe the router is damaged.

Alex.RSG

LV1

2019-06-21 14:21:39 - last edited 2021-04-19 12:08:33

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-06-06

Re:Re:After updating the firmware do not access the firewall.

2019-06-21 14:21:39 - last edited 2021-04-19 12:08:33

That's right, I tried to perform the reset this way but the SYS led doesn't blink. I believe it was damaged.

Obrigado, Tks.

After updating the firmware do not access the firewall.

After updating the firmware do not access the firewall.

Information

Voters 0

Tags