EAP-115WALL cannot adopt
Hello
i had 2 EAP115 wall working good with omada controller
today i installed the 3rd one and suddently the 2 already installed went disconnected on the controller (dispite having internet acess by them )
the 3rd one could not been adopted and the other ones cannot also re-adopt. even resetted all of them and always the same error
error is:
Failed to send adopt command to AP
near the ? it says username or password are not correct ! but they are correct ! even after changing password or resseting device always same problem
how can i solve this?
thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
You say when you adopt the EAP, it will tell you "Failed to send adopt command to AP". Normally it is related to the network topology. When the Omada Controller tries to send the adopt command to the AP, it will failed, thus, it can not adopt the AP successfully.
You can close the anti-virus/firewall for checking. And you can try to ping the EAP on the Controller host. If you can ping the EAP successfully, then you just reset the EAP and try again.
- Copy Link
- Report Inappropriate Content
thanks a lot !
what i can see is that if i turn off my main router wifi network, the AP's disconnect altough apparently they are working...
basically i want to disable my main router wifi and only have wifi from the AP....
i think there is somekind on conflict that i cannot solve
btw, mesh is not possible to implement on this AP's?
- Copy Link
- Report Inappropriate Content
Hi,
EAP115-Wall doesn't support mesh.
Now, only EAP225-Outdoor and EAP225v3 support mesh, EAP245v3 will also support mesh later.
- Copy Link
- Report Inappropriate Content
and will not be available on the future?
thanks
- Copy Link
- Report Inappropriate Content
Hi,
We have no plan to add this feature on EAP115-Wall for now, but we will consider it.
- Copy Link
- Report Inappropriate Content
@forrest hi i was having a problem with my router EAP245 that i cant adopt it. I dont know what wrong. But somehow my phone is able to connect it but my laptop was having a problem that i am using the Omada Controller on my PC i have try so many times but still it doesnt work. The error message is "Failed to send adopt command to the AP".
- Copy Link
- Report Inappropriate Content
Try to reset the EAP and adopt it again, and your issue should be solved.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3835
Replies: 7
Voters 0
No one has voted for it yet.