T1600G-28PS Smart Switch ACL
T1600G-28PS Smart Switch ACL
HI guys.
Just started palying around with this nice smart switch, configured a few vlans, L3 features are used to route between LAN's, the switch is easy to configure and I like it, but one i cant get working: its ACL's
I want to stop traffic between two VLAN's 11 and 12. 192.168.x.x/24 and 192.168.y.y/24
Im creating a IP based ACL and rules under it. Two rules to drop packet from one to other and oposite on other rule.
So it should drob what comes from x.x to y.y and from y.y to x.x
But nothing gets droped packets are going through.
Could you bring in how ACL's works on TP link smart switches.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi TheDreamer
As I know, if your T1600G-28TS is version 3.0, please note that every ACL has an implicit deny all rule at the end of an ACL rule list. That is, if an ACL is applied to a packet and none of the explicit rules match, then the final implicit deny all rule takes effect and the packet is dropped. You also can find this notification on T1600G-28TS configuring guide.
About SG1016DE, it's too old, I think there will not be new firmware.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3531
Replies: 11
Voters 0
No one has voted for it yet.