Business Community > WiFi > EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
< WiFi

EAP-110 Outdoor AP not retaining configuration on auto nightly reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

EAP-110 Outdoor AP not retaining configuration on auto nightly reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-13 02:19:46 - last edited 2019-01-20 02:15:04

We are currently using 7 EAP-115 and 1 EAP-110 outdoor APs in our apartment society gates for Wifi Access to MyGate Tablets. Recently we have observed a niggling problem with the EAP-110 outdoor unit that after reboot it does not ratain has its configuration and has to be manually adopted and WLAN group reconfigured. Here is the controller log:

 

 

(1) All our APs are configured to restart at 4:00 am in the morning everyday,

(2) The  Outdoor AP (70-4F-57-74-40-B2) also follows this routine but when it restarts it does not come back to its configured state like other indoor APs (EAP-115s with macs ending with F2, F8, 4B octets in picture), despite controller being kept on. It just goes into Pending state with the correct IP and connectivity (layer 3 networking sems just fine because it is able to get on the network)..

(3) To bring out of its pending state, we have to

    (a) manually adopt the AP

    (b) assign it to the correct site and configure the WLAN Group on the AP again

(4) After this the problem goes away for a day or 2 or 3, till it reappears.

 

This has started happening after we switched from Auranet Controller to latest Omada Controller (now running 3.0.5)  OR one of the Omada Controller software upgrades. It was defintely not observed for 6-8 months of operation with the Auranet Controller

 

Any pointers to debug further or resolve will be appreciated.

 

  0      
 
  0      
 
#1
Options
14 Reply
Re:EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-15 03:06:21

Hi,

 

What's the firmware/hardware version of EAP110-Outdoor? It seems that the EAP110-Outdoor will reset itself automatically. If you are using EAP110-Outdoor v1, please try to upgrade the beta firmware for the automatical resetting problem of EAP110-Outdoor.

 

File:
TL-EAP110-OUTDOORv1_1.2.0_[20180808-rel61398]_up_signed.zipDownload
  4  
  4  
#2
Options
Re:Re:EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-15 04:22:38

Thanks Jonas.

 

The EAP 110 Outdoor AP hardware version is 1.0 (EU) and its using firmware 1.1.0 Build 20170914 Rel. 63009 which the Omada Controller reports as upto date.

 

Will the firmware version shared by you for manual upgrade work for this hardware version ?

 

Regards

Suman @ APRC-P3 Telecom WG

  0  
  0  
#3
Options
Re: EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-15 17:31:14 - last edited 2019-01-15 17:33:38

APRC-P3-Tel wrote

Will the firmware version shared by you for manual upgrade work for this hardware version ?

 

Yes, it can be updated manually - just did so with my EAP110-Outdoor v1.

 

Thanks jonas, from me, too.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:Re: EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-16 01:55:34

Hi R1D2, you are welcome!!yes

  0  
  0  
#5
Options
Re:Re:Re:EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-16 01:56:55

APRC-P3-Tel wrote

Thanks Jonas.

 

The EAP 110 Outdoor AP hardware version is 1.0 (EU) and its using firmware 1.1.0 Build 20170914 Rel. 63009 which the Omada Controller reports as upto date.

 

Will the firmware version shared by you for manual upgrade work for this hardware version ?

 

Regards

Suman @ APRC-P3 Telecom WG

 

Yes, it was made for EAP110-Outdoor. Please try to upgrade this beta firmware to check if it can solve your problem.

  0  
  0  
#6
Options
Re:Re:Re:Re:EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-17 02:29:15

Upgraded successfully. The problem did not occur yesterday. Will keep the controller on for a week and observe. And after that shut it down and observe for another week. if no problem, than your solution resolves the issue (will report here).

 

Thanks for your support.

 

Regards

Suman @ APRC-P3 Telecom WG

  0  
  0  
#7
Options
Re:Re:Re:Re:Re:EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-19 17:26:21 - last edited 2019-01-20 02:22:18

After upgrading the AP and observing for few days, the problem did not occur. Frequency of problem appearing seems to have decreased, But on the 3rd reboot or 4th day it agin resurfaced.

 

 

 

 

 

I reperformed the two steps of adopting and reconfiguration to get the AP back online. All this while the controller was on. I am shutting down the controler application and testing if the problem is due to controller - AP interaction at scheduled reboot.

 

 

Thanks and Regards

Suman @ APRC Telecom Working Group

  0  
  0  
#8
Options
Re: EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-20 16:16:54 - last edited 2019-01-20 16:23:00

Just for the record: I had no more nightly reboots of EAP-110 Outdoor since update to the beta firmware, but a) when it sporadically rebooted before every 24 hours (unscheduled reboots were our problem!), it didn't lose adoption state and b) I'm still using controller v2.7.0.

 

If it might help you, I can configure a scheduled reboot to see wether it loses association to the controller, too.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#9
Options
Re:Re: EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-21 18:34:24

Yes. you may try. I just know following diagnostic information from our setup:

 

1. The problem likely happens when PC controller is *left running [I do it because i want to monitor & manage something if required via Omada Cloud using phone/ipad]

2. The problem started occuring *only after we moved from Auranet to Omada Controller

3. The AP in questions runs fine all day, but after one *scheduled nightly reboot, it fails to come back online. It happens every N days (N = 3 atleast) but defintely not daily.

 

in our case we are doing nightly reboot to clear up any software issue and avoid maintaining the APs most of the time (which worked for almost a year).

 

The APs and controller are in same VLAN. 

 

Regards

Suman @ APRC-P3 Telecom WG

 

 

  0  
  0  
#10
Options
Re: EAP-110 Outdoor AP not retaining configuration on auto nightly reboot
2019-01-24 05:39:34

Works so far ... Two EAP110-Outdoor rebooted tonight (I observed the reboot) and both came back connected, no need to adopt them again. Will observe this next few days.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#11
Options
12

Information

Helpful: 0

Views: 5961

Replies: 14

Related Articles
 configuration of my EAP 110 Outdoor
876 0
Can I re-configure Eap 110 outdoor v3 with higher hardware version such as V5?
76 0
 Can't configure EAP 110 v2
989 0
EAP-110 AND EAP-110 OUTDOOR Seamless/fast roaming
3763 0
TP Link EAP 245 Multi AP Configuration V2
4933 0
INCOMPATIBLE - CONFIGURATION RESULT for all my EAP
921 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.