TP Link EAP225 AC 1200 Ver 2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP Link EAP225 AC 1200 Ver 2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link EAP225 AC 1200 Ver 2
TP Link EAP225 AC 1200 Ver 2
2018-07-04 14:52:20
Model : EAP225

Hardware Version :

Firmware Version : 1.4.0 Build 20180323 Rel. 32579(5553)

ISP :

We installed recently EAP225 after installation and configuration we face a problem
Our Network Printers and other LAN gadgets not accessible with that Access Point. these gadgets have reserve IPs.

When we change AP we can access that gadgets.
Please help me to solve this problem.
  0      
  0      
#1
Options
3 Reply
Re:TP Link EAP225 AC 1200 Ver 2
2018-07-06 05:02:28
Post screenshot of configuration (especially wireless settings if you use EAP Controller for configuration).
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:TP Link EAP225 AC 1200 Ver 2
2018-07-07 03:22:39
More or less I had the same issue, when Chromecast was connected on 5G and my phone on 2G it wasn't visible,even if multicast on another layer was forced. Somehow 2G/5G bonding is not perfect with all of the accessible firmware
  0  
  0  
#3
Options
Re:TP Link EAP225 AC 1200 Ver 2
2018-07-07 07:41:21
Again, post config.

If you enable AP isolation, you can't connect to other wireless clients. If you configure default blocking ACL rules, you can't even connect to LAN devices.

If you set it up correctly, you will be able to connect to LAN devices and even to other wireless clients.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options