CPE210 Setup Help
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210 Setup Help
Model : CPE210
Hardware Version : 1.1
Firmware Version : 2.1.6 Build 20170908 Rel. 45233(5553)
ISP : Frontier
I just got Frontier DSL. It's IP is 192.168.254.254
So I set the CPL up as 192.168.254.111
I plug it in to the modem and it connects and looks like it's working when I log into the modems management page.
Problem is when I try and connect to the CPE wireless I get incorrect password. If I take protection off I get unable to join network.
Usually a router has a wan side and a lan side, when I set this up as AP it only has a network tab for the lan.
So I'm missing something I guess.
I had this one set up as a client before and it was doing ok but I'm switching to Frontier now.
The frontier is in a different building then where I need it so I'm using one CPE to send wireless and another to catch it.
Do I have to have my whole network on the .254.xxx net? I usually use 0.xxx.
Any help appreciated.
Thanks
Hardware Version : 1.1
Firmware Version : 2.1.6 Build 20170908 Rel. 45233(5553)
ISP : Frontier
I just got Frontier DSL. It's IP is 192.168.254.254
So I set the CPL up as 192.168.254.111
I plug it in to the modem and it connects and looks like it's working when I log into the modems management page.
Problem is when I try and connect to the CPE wireless I get incorrect password. If I take protection off I get unable to join network.
Usually a router has a wan side and a lan side, when I set this up as AP it only has a network tab for the lan.
So I'm missing something I guess.
I had this one set up as a client before and it was doing ok but I'm switching to Frontier now.
The frontier is in a different building then where I need it so I'm using one CPE to send wireless and another to catch it.
Do I have to have my whole network on the .254.xxx net? I usually use 0.xxx.
Any help appreciated.
Thanks