T1700G-28TQ port isolation
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T1700G-28TQ port isolation
Hi folks,
I believe there is a bug in the port isolation web interface (Switching -> Port -> Port Isolation).
I click on Edit, select the ports and Apply. On the Port Isolation List I see settings are applied, but I have no ways to modify it. I can add others, displays ok, but again cannot edit nor revert them.
At this point when I click on Edit I should get few "Selected" and "Not Available" ports, but all are "Unselected".
I've tried Opera, Firefox, Chrome and IE but still no way to edit or revert without a reboot.
Tests were luckily done on unused ports so no harm was done, I'll reboot it tonight.
Am I missing something here.
Cheers
Model : T1700G-28TQ
Hardware Version : T1700G-28TQRev2
Firmware Version : 2.0.1 Build 20170608 Rel.61525(s)
I believe there is a bug in the port isolation web interface (Switching -> Port -> Port Isolation).
I click on Edit, select the ports and Apply. On the Port Isolation List I see settings are applied, but I have no ways to modify it. I can add others, displays ok, but again cannot edit nor revert them.
At this point when I click on Edit I should get few "Selected" and "Not Available" ports, but all are "Unselected".
I've tried Opera, Firefox, Chrome and IE but still no way to edit or revert without a reboot.
Tests were luckily done on unused ports so no harm was done, I'll reboot it tonight.
Am I missing something here.
Cheers
Model : T1700G-28TQ
Hardware Version : T1700G-28TQRev2
Firmware Version : 2.0.1 Build 20170608 Rel.61525(s)
Re:T1700G-28TQ port isolation
Yes, forward port were setup, in fact I could see (via ssh I could only look at settings, via telnet I could also set) all applied settings used by me to test.
Other functions like LAGG, VLAN, Spanning ecc are working great from a while.
### Before web and telnet
### Edit
### After settings are applied web and telnet show proper config changes, but Edit page is blank so I cannot undo or add anything else... well I could add, but blindly or having two tabs open:
Other functions like LAGG, VLAN, Spanning ecc are working great from a while.
### Before web and telnet
### Edit
### After settings are applied web and telnet show proper config changes, but Edit page is blank so I cannot undo or add anything else... well I could add, but blindly or having two tabs open:
File:
