EAP330 - Spread Clients evenly over 2.4 and 5 Ghz.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP330 - Spread Clients evenly over 2.4 and 5 Ghz.
Model :
Hardware Version :
Firmware Version :
ISP :
Hello
I understand that an EAP330 can handle between 25 and 30 clients per Radio. I have one EAP330 setup in a hall with an SSID of "hallg" on both 2.4 and 5 Ghz. When I look at the Monitoring SSID in the EAP Web Interface, I note that 5 Ghz has 50 Clients and 2.4 Ghz only has 8 or so.
Is there a way to have EAP spread the clients evenly among the 2 frequencies without creating a separate SSID for each frequency??
Thanks in Advance for suggestions related to my question.
Hardware Version :
Firmware Version :
ISP :
Hello
I understand that an EAP330 can handle between 25 and 30 clients per Radio. I have one EAP330 setup in a hall with an SSID of "hallg" on both 2.4 and 5 Ghz. When I look at the Monitoring SSID in the EAP Web Interface, I note that 5 Ghz has 50 Clients and 2.4 Ghz only has 8 or so.
Is there a way to have EAP spread the clients evenly among the 2 frequencies without creating a separate SSID for each frequency??
Thanks in Advance for suggestions related to my question.
Re:EAP330 - Spread Clients evenly over 2.4 and 5 Ghz.
In general, you can enable load balance on EAP330 on its web UI (in standalone mode). By setting the maximum number of clients accessing the EAPs, Load Balance helps to achieverational use of network resources. Shown as the attachment, Input 30 clients for 2.4Ghz and 5Ghz.
File:
