TL-R600VPN - NAT all local LAN traffic destined for the VPN tunnel - Is it possible?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R600VPN - NAT all local LAN traffic destined for the VPN tunnel - Is it possible?
Model :
Hardware Version :
Firmware Version :
ISP :
Hello everyone,
I am very new to VPN and the TP link routers an I am counting that someone here will be able to help.
We are using TL-R600VPN router and some of our services have changed and will require vpn connection going forward.
To make this short, I need to setup an IPSEC site to site connection with service provider and they require that we NAT all local traffic destined for the tunnel because it will only allow single IP address. Creating VPN connection following the instructions was fairly easy, but I am stock at the NAT part. I do not see any options for NAT in the router GUI.
Is this scenario possible with TL-R600VPN?
Thank you.
Hardware Version :
Firmware Version :
ISP :
Hello everyone,
I am very new to VPN and the TP link routers an I am counting that someone here will be able to help.
We are using TL-R600VPN router and some of our services have changed and will require vpn connection going forward.
To make this short, I need to setup an IPSEC site to site connection with service provider and they require that we NAT all local traffic destined for the tunnel because it will only allow single IP address. Creating VPN connection following the instructions was fairly easy, but I am stock at the NAT part. I do not see any options for NAT in the router GUI.
Is this scenario possible with TL-R600VPN?
Thank you.
